Handling Wires And Harnesses; Testing And Repairs - Honda Prelude 1993 Service Manual

Troubleshooting
Tips and Precautions (cont'dl
a Insert the connector all the way and make sure it is
securely locked.
a Position wires so that the open end ol the cover
f a c e s d o w n .
Fac6
open ond
V
Hsndling Wilos and Halnossos
a Secure wires and wire harnesses to the frame with
their respective wire ties at the designated locations.
a Remove clips caretully; don't damage their locks.
Slip pliers under the clip base and through the hole at an
angle, then squeeze the expansion tabs to release the
c x p .
After installing harness clips, make sure the harness
doesn't inter{ere with any moving parts.
Keep wire harnesses away from exhaust pipes and
other hot parts, lrom sharp edges of brackets and
holes. and from exposed screws and bolts.
SNAP.RING PI-IER
23-4
NOT GOOO
A
-M/
-Y-
--P\
l l l r
Testing and Repairs
a Do not use wires or harnesses with broken insulation.
Replace them or repair them by wrapping the break
with electrical tape.
a After installing parts, make sure that no wires are
pinched under them.
a When using electrical test equipment, follow the
manufacturer's instructions and those described in
this manual.
a lf possible. insert the probe of the tester from the wire
side (except waterproof connector).
a Seat grommets In lheir grooves properlv.
a Use a probe with a tapered tio.
ReIer to the instructions in the Honda Terminal Kit for
identification and reDlacement of connector terminals.