Honda Prelude 1993 Service Manual page 960

8.
Pack adhesive into the cartridge without air pockets
to ensure continuous delivery. Put th€ cartridge in a
calking gun and run a bead of adhssive around the
edgs of the quarter glass as shown.
NOTE:
Apply the adhesive whhin 30 minutes after applying
the glass primer,
13 mm
{O.51 Inl
Msk€ a slghtv thicker
boad at 6ach coln6r.
6 mm (O23 In)
2 mm (0,08 Inl
-Tr
n:ADHEsrvE
H
8 m m
{0.31 Inl
- t
i , l T ,
- H i i , = * r
f z _ )
L _ * _ - _
OUARTER GLASS MOLDI G
20-27
CLIP
CLIP
9 . Use suction cups to hold the quarter glsss over tt|€
opening, align it with the clip setting points and s€t it
down on the adheisive, Lightly push on the quaner
glass until its edges are fully seated on the adhesive a[
the way around.
NOTE:
Do not oDen or close the doors until the adhosivo is
drv.
SUCTK)N
CUPS
1 0 .
1 1 .
Scrspe or wipe the excess adhesive off wlth a putty
knife or towel,
NOTE:
Use a soft shoD towel damDened with alcohol to
remove adhesive from a painted surlace or quaner
gEss.
After the adhesive is dry, spray water over the
quarter glass and check for leaks. Mark leaking areas
and let the quaner glass dry, then seal with sealant.
NOTE:
Let the car stand for at least four hours after ouarter
glass installation. It the car has to be used within the
first four hours, it must be driven slowly.
Reinstall all remaining removed parts.
12.