Clutch Overhaul - Honda Prelude 1993 Service Manual

Clutch Overhaul
Remove the center nut while holding the armature
plate.
CENTER NUT
18 N.m 11.8 kg-m, 13lb-ft1
A,/C CLUTCH HOLDER
Commorcirlly av6ihble
Robin.ir: P/N 10204
Kent-Moore: P/N J3?872
Remove the armature plate by pulling it up by hand.
lf you can not remove it by hand, attach the fly-
wheel puller to the armature plate, screw the bolt in
the center and remove the armature plate.
FLYWHEEL PULLER
07935-8050003
@)
3.
Remove the snap ring B with a snap ring pliers.
NOTE:
. Once the snap rjng B is removed, replace it with
a new one.
a Be caretul not to damage the compressor body
and rotor pulley during removal/installation.
ROTOR
PULLEY
Remove the rotor pulley from the shaft with a puller
and the special tool.
NOTE: Put the claws ofthe puller on the back ofthe
r o t o r p u l l e y , n o t o n t h e b e l t a r e a ; o t h e r w i s e t h e
rotor pulley can be damaged.
SEAL DRIVER
07945-4150200
(cont'd)
A
\ /
:
22-37