Honda Prelude 1993 Service Manual page 630

3. After instaliing the thrust shim, install the outer race
in the transmission housing, using the special tools
as snown.
CAUTION:
. Install the outsr .ace squaraly in tho trsnsmi!.
sion housing.
. Check that thero is no cloaranco bciwocn th,
outsr race, shim and t ansmission housing.
. Install tho gasket whon chocking pr6lo6d.
07?49 - qlrqtoo
With the mainshaft, countershaft and secondarv
shaft removed, install the differential assembly and
torque the transmission housing.
TOROUE: 55 N.m 15.5 kg-m. /r0 lb-ft|
Rotate the differential assembly in both directions
to seat the bearings.
,'l
6 , M e a s u r e t h e s t a r t i n g t o r q u e o f t h e d i f f e r e n t i a l
assembly with the special tool and a to.que wrench.
STANDARD:
Now bosrings:
2.8 -,[.0 N'm
128 - ,l|) kg-cm, 2,1- 35 lb-inl
Rculod bslrings: 2.5 - 3.7 N.m
(25 - 37 kg-cm, 22 - 32 lb-in)
PRELOAD INSPECTION TOOL
07HAJ - PKIO201
NOTE:
! Measu.e the starting torque at normal room tem-
p6.ature in both directions.
lf out of spec, select two thrust shims which will
give the correct preload, and repeat steps 1 - 6.
Changing one of the shims to the next size will
increase or decrease staning torque about 3 - 4
kg-cm (2.60 - 3.,17 lb-ln).
T o i n c r e a s e t h e s t a r t i n g t o r q u e , i n c r e a s e t h e
t h i c k n e s s o f s h i m s . T o d e c r e a s e t h e s t a r t i n g
torque, decrease the thickness of shims.
1 5 - 1 9