Removing The Left Deck Pickup Solenoid; Adjusting The Position Of The Left Deck Pickup Solenoid; Manual Feed Pull-Out Roller Unit; Removing The Manual Feeding Pickup Roller Unit - Canon iR5055 Series Service Manual

3) Detach the rear cover (lower). (page 10-13)Reference[Removing the
Rear Cover (Lower)]
4) Remove the HVT PCB. (page 10-28)Reference[Removing HVT PCB]

8.11.12.2 Removing the Left Deck Pickup Solenoid

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Mark the position [A] of the 2 mounting bases.
2) Remove the left deck pickup drive solenoid [3] together with the mounting
base.
- 1 connector [1]
- 1 screw [2]
[A]
8.11.12.3 Adjusting the Position of the Left Deck Pickup
Solenoid
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
Before removing the left deck pickup solenoid from the support plate [1],
take note of its position with reference to the fixing screw [2] of the solenoid.
Or, mark the position for the solenoid by drawing a line on the support plate
with a scriber.
When mounting the solenoid on its own, be sure to secure it in its original
position.
[2]

8.11.13 Manual Feed Pull-Out Roller Unit

8.11.13.1 Removing the Manual Feeding Pickup Roller

Unit
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Open the right door unit (upper) [1], and remove the screw [2] from the
door strap and then, fully open the right door unit (upper).
2) Slide the 2 bushings [2] and remove the manual feeding pickup roller unit
[3].
[3] [1]
[2] [A]
F-8-85
[1]
F-8-86
[2] [1]
F-8-87
- 2 resin E-rings [1]
0015-5007
[3]

8.11.14 Manual Feed Pull-Out Roller

8.11.14.1 Before Removing the Manual Feeding Pickup
Roller
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the manual feeding pickup roller unit. (page 8-37)Refer-
ence[Removing the Manual Feeding Pickup Roller Unit]
8.11.14.2 Removing the Manual Feeding Pickup Roller
0016-0029
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the 2 resin E-rings (right/left) [1].
2) Remove the stopper [2], the 2 guars [3] and the 2 bushings [4].
3) Remove the 2 resin E-rings [5] and the 2 bushings [6], and then remove
the manual feeding pickup roller.
When removing the stopper [2] and the guar [3], be careful not to lose the
three parallel pins [7]; they will slip off.
0015-5009
[1]
[2]
F-8-88
Chapter 8
0015-9388
0015-9389
8-37