Feeder - Canon iR5055 Series Service Manual

Sub-item Description
MF-A4R Use it to enter the paper width basic value for the manual feed tray (A4R).
adjustment range: 0 to 255
MF-A6R Use it to enter the paper width basic value for the manual feed tray (A6R).
adjustment range: 0 to 255
MF-A4 Use it to enter the paper width basic value for the manual feed tray (A4).
adjustment range: 0 to 255
C3-LVOL Use it to enter the capacity of the cassette 3 (50 sheets).
adjustment range: 0 to 255
C3-HVOL Use it to enter the capacity of the cassette 3 (275 sheets).
adjustment range: 0 to 255
C4-LVOL Use it to enter the capacity of the cassette 4 (50 sheets).
adjustment range: 0 to 255
C4-HVOL Use it to adjust the capacity of the cassette 4 (275 sheets).
adjustment range: 0 to 255
<MISC>
Sub-item Description
ATM Use it to make settings related to the atmospheric pressure of the site of installation.
settings range: 0 to 2 (default: 0)
0: 1 to 0.75 atm (up to elevation of 2500 m)
1: 0.75 to 0.70 atm (elevation between 2500 and 300 m)
2: 0.70 to 0.65 atm (elevation between 300 and 3500 m)

17.4.2 FEEDER

17.4.2.1 FEEDER List
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
Sub-item Description
DOCST Use it to adjust the original image leading edge position.
- a higher setting will delay the timing for the image leading edge.
adjustment range: -50 to 50 (unit: 0.1 mm)
LA-SPEED Use it to adjust the original feed speed in feeder stream reading mode.
- a higher setting will increase the speed (i.e., contracts the image).
adjustment range: -30 to 30 (unit: 0.1%)
DOCST2 Adjustment of VYSNC timing on the backside of the feeder at simultaneous double-sided reading.
adjustment range: -50 to 50 [default: 0] (unit: 0.1mm)
LA-SPEED2 Use it to adjust the sub scanning magnification in feeder back stream reading mode for duplex simultaneous reading.(for fine
adjustment of HSYNC length)
adjustment range: -120 to 120 [temporary] (unit: 0.1%)
17.4.3 SORTER
17.4.3.1 SORTER List
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
Sub-item Description
PNCH-HLE Use it to adjust the length from the edge of paper to the punch hole.
settings range: -4 to 2 (unit: mm)
17.5 FUNCTION (Operation/Inspection Mode)
17.5.1 COPIER
17.5.1.1 COPIER List
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
<INSTALL>
COPIER > ADJUST > CST-ADJ
T-17-29
COPIER > ADJUST > MISC
T-17-30
COPIER > FEEDER > ADJUST
T-17-31
COPIER > SORTER > ADJUST
Chapter 17
Level
1
1
1
1
1
1
1
Level
1
0015-5843
Level
1
1
1
1
0015-5845
Level
1
0015-5971
17-27