Connecting The Cable; Checking The Environment Switch - Canon iR5055 Series Service Manual

Chapter 2
[2]
6) Close the toner replacement cover.
When turning on the main power switch without setting toner container, the
toner level meter on the control panel shows 25 % or less. Make sure that the
toner container is set in the host machine before turning on the main power
switch.

2.2.10 Connecting the Cable

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Connect the ADF power cable [1] and attach the wire saddle [2].
[1]
[2]
2) Connect the connector [1] of the ADF communication cable and the con-
nector [2] of the reader communication cable.
3) Put the ADF communication cable and the reader communication cable
through the cable cover [1], and then remove the release paper on the ca-
ble cover and attach it on the position shown in the figure.
2-12
[1]
F-2-40
F-2-41
[2] [1]
F-2-42
4) Connect the connector [1] of the ADF communication cable.
0015-4665
5) Connect the connector [1] of the reader communication cable and secure
it with the wire saddle [2].
[1]

2.2.11 Checking the Environment Switch

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Make settings for environment switch [1] and the cassette heater switch
[2] according to the environment of the installation site. In case the drum/
cassette heaters are required to be turned on while the main power switch
is turned off, make settings with the following 2 switches:
Drum heater
ON
Environment switch ON
Main power switch ON
[1]
F-2-43
[1]
F-2-44
[2]
F-2-45
T-2-4
OFF
Environment switch OFF
Main power switch OFF
0015-4667