Manual Feed Tray Paper Sensor; Removing The Manual Feeding Tray Sensor; Registration Roller; Before Removing The Registration Roller - Canon iR5055 Series Service Manual

hole A
hole B

8.11.17 Manual Feed Tray paper sensor

8.11.17.1 Removing the Manual Feeding Tray Sensor

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Open the right door unit (upper) [1], and remove the screw from the door
strap; and then fully open the right door unit (upper).
2) Detach the cover [2].
- 1 screw [1]
[1]
3) Remove the sensor unit [2].
- 1 screw [1]
4) Free the harness [1] from the edge saddle [2], and disconnect the connec-
tor [3].
5) Remove the sensor [4].
[1]
[2]
F-8-94
[2] [1]
F-8-95
[2]
F-8-96
[1] [2]
F-8-97
[2]
0015-5016

8.11.18 Registration Roller

8.11.18.1 Before Removing the Registration Roller

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Detach the duplexing feed front cover.(page 10-14)Reference[Remov-
ing the Duplexing Feed Front Cover]
2) Remove the fixing/feeding unit. (page 9-19)Reference[Removing the
Fixing/Feeding unit]
3) Remove the transfer/separation charging assembly.(page 7-30)Refer-
ence[Removing Transfer/Separation Charging Assembly]
4) Remove the registration clutch.(page 8-43)Reference[Removing the
Registration Clutch]

8.11.18.2 Removing the Registration Roller

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Detach the protection cover [2].
- 1 screw [1]
2) Remove the followings from the rear side.
- spring [1]
- E-ring [2]
- spacer [3]
- bearing [4]
- stopper [5]
[1]
[3] [4]
F-8-98
[2]
[1]
F-8-99
Chapter 8
0015-5017
0015-5020
8-39