Counter (Counter Mode) - Canon iR5055 Series Service Manual

Chapter 17
4) Inform the system administrator that you are going to check the network connection, and find out the remote host address (i.e., the IP address of a PC terminal
on the user's network).
5) Make the following selections in service mode: COPIER>TEST>NETWORK>PING; then, type in the IP address you obtained in step 4) When ready, press the
OK key and then the Start key.
- The indication will be 'OK' if the connection to the network is correct. (End the work.)
- If the indication is 'NG', on the other hand, check the connection of the network cable; if the cable is normal, go to step 6). If a fault is found in the cable, correct
it, and go back to step 5).
6) Make the following selections in service mode: COPIES>TEST>NETWORK>PING. Then, enter the local host address (i.e., IP address of the machine), and
press the OK key.
- If the indication is 'NG', suspect a fault in the IP address of the machine or of the network controller. Ask the system administrator for a check on the IP address,
or replace the main controller PCB.
- If the indication is 'OK', on the other hand, the network settings and the network controller may be assumed to be normal. If so, suspect a fault in the user's network
environment; report to the system administrator for remedial work.
7) Make the following selections in service mode: COPIER>TEST>NETWORK>PING; then, enter the local host address (i.e., IP address of the machine), and
press the OK key.
- If the notation is 'NG', suspect a fault in the IP address of the machine or in the network controller. Contact the system administrator to obtain the correct IP address
or replace the main controller PCB.
- If the notation is 'OK', the network settings and the network controller may be assumed to be free of faults. The fault is likely to be in the user's network environ-
ment. Contact the system administrator for remedial action.

17.8 COUNTER (Counter Mode)

17.8.1 COPIER
17.8.1.1 COPIER List
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
<TOTAL>
Sub-item Description
SERVICE1 total counter 1 for service
Increases the count when paper is discharged outside the machine.
(regardless of the size of paper, i.e., large or small)
after 99999999, resets to 00000000
SERVICE2 total counter 2 for service
Increases the count when paper is discharge outside the machine.
(in the case of large size, increases by 2; in the case of small size, increases by 1)
after 99999999, resets to 00000000
COPY total copy counter
Increases the count when copying is over and the paper is discharged outside the machine.
after 99999999, resets to 00000000
PDL-PRT PDL print counter
Increases the count when paper is discharged outside the machine or duplex stacking occurs to suit the charge counter in PDL print
mode.
in the case of a blank sheet, the count remains unchanged; for both large and small sizes, the count is increased by 1
after 99999999, resets to 00000000
FAX-PRT fax reception print counter
Increases the count when paper is discharged outside the machine or duplex stacking occurs to suit the charge counter in fax
reception mode.
in the case of a blank sheet, the count remains unchanged; for both large and small sizes, the count is increased by 1; the reading
may be reset
after 99999999, resets to 00000000
RMT-PRT remote print counter
Increases the count when paper is discharged outside the machine or duplex stacking occurs to suit the charge counter in remote
print mode.
in the case of a blank sheet, the count remains unchanged: for both large and small sizes, the count is increased by 1; the reading
may be reset
after 99999999, resets to 00000000
17-64
Result (OK/NG) IP address input
F-17-15
T-17-64
COPIER > COUNTER > TOTAL
0015-5953
Level
1
1
1
1
1
1