Test (Test Print Mode) - Canon iR5055 Series Service Manual

Sub-item Description
MENU-1 to 4 Use it to enable/disable display of levels 1 thorough 4 for the printer settings menu.
setting
0: disable (do not display; default)
1: enable (display)

17.7 TEST (Test Print Mode)

17.7.1 COPIER
17.7.1.1 COPIER List
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
<PG>
Sub-item Description
TYPE Enter the type No. of the desired test print, and press the Start key to print out a test print. (Be sure to return it to '0' after printing.)
0: image from CCD (normal print)
1: grid
2: 17 gradations (error diffusion; T-BIC)
3: 17 gradations (dither screen)
4: blank 00H
5: halftone 80 H (error diffusion; T-BIC)
6: halftone 80 H (dither screen)
7: solid black FFH
8: horizontal line (space: 27 dots; line width: 4 dots)
9: horizontal line (space: 50 dots; line width: 6 dots)
10: horizontal line (space: 3 dots; line width: 2 dots)
11: halftone 60H (error diffusion; T-BIC)
12: halftone 60H (dither screen)
13: halftone 30H (error diffusion: T-BIC)
14: halftone 30H (dither screen)
15: 17 gradations (text mode)
16: 17 gradations (text/photo mode)
17: 17 gradations (print photo mode)
18: 17 gradations (film photo mode)
19: for R&D
20: 17 gradations (PDL screen: medium resolution)
21: 17 gradations (PDL screen: low resolution)
22: 17 gradations (PDL screen: high resolution)
23 to 30: for R&D
TXPH Use it to switch between text mode or photo mode for test printing.
setting: 0 to 4
PG-PICK Use it to select the source of paper for test printing.
1: right deck
2: left deck
3: cassette 3
4: cassette 4
5-6: not used
7: side deck
8: multifeeder
2-SIDE Use it to select the output mode for test printing.
setting
0: simplex
1: duplex
(at time of shipment/upon RAM initialization: 0)
PG-QTY Use it to select the output mode for test printing.
Use it to set a copy count for test printing.
1 to 999 (default: 1)
<NETWORK>
Sub-item Description
PING Use it to check the connection between the machine and a network (only if TCP/IP).
Use it when checking the connection at time of installation or in the event of a network connection fault.
1) Hold down the control panel switch to start shut-down sequence. When ready, turn off the main power switch.
2) Connect the network cable to the machine, and turn on the main power switch.
3) Inform the user's system administrator that the installation of the machine is over, and ask him/her to make network settings.
COPIER > BOARD > OPTION
T-17-62
COPIER > TEST > PG
T-17-63
COPIER > TEST > NETWORK
Chapter 17
Level
2
0015-5967
Level
1
1
1
1
1
Level
1
17-63