Canon iR5055 Series Service Manual page 567

Sub-item Description
ENV-PRT Use it to print out a log of changes in the machine inside temperature/humidity and in fixing temperature.
The log will show changes in the machine inside temperature/humidity and in fixing temperature (center) collected from the
monitor outputs of the non-contact thermistor and the environment sensor.
1) Select the item.
2) Press the OK key to generate a printout.
KEY-HIST Use it to print out the history of control panel key inputs.
1) Select the item.
2) Press the OK key to generate a printout.
TRS-DATA Transition of memory reception data.
Transmit the memory reception data to the data BOX.
Operation Method:
1) Select the item.
2) Press [OK] so that the data is transmitted.
LBL-PRNT Print the service label.
Print the description on the service label.
Operation Method:
1) Set an A4/LTR in Cassette 1.
2) Select the item.
3) Press [OK] so that the label is printed.
It will take about 15 sec to start printing.
HIST-PRT Use it to print out the jam history and the error history.
Procedure
1) Select the item.
2) Press the OK key to generate a printout.
<SENS-ADJ>
Sub-item Description
STCK-LMT Use it to adjust the position of the shift tray full sensor.
If the tray is full, 'on' will be indicated; if empty, 'off' will be indicated.
<SYSTEM>
Sub-item Description
DOWNLOAD Use it to switch to download mode.
Procedure
1) Select the item.
2) Press the OK key to start download mode.
CHK-TYPE Use it to select the appropriate partition number for execution of HD-CHECK or HD-CLEAR.
Procedure
1) Select the item.
2) Select the number of the partition you want using the keypad.
0: entire HDD (*1, *2)
1: image storage area
2: general-purpose file (user settings data, log data, PDL spool data) storage area
3: PDL-related file storage area
4: firmware storage area (*1, *2)
5: MEAP area
6: address book area (*1)
*1: cannot be initialized using HD-CLEAR.
*2: can be initialized using the SST.
HD-CHECK Use it to check and recover the partition you have selected using CHK-TYPE.
procedure
1) Select the item.
2) Press the OK key.
3) See the result. (1: OK; 2: NG (hardware); 3: NG (software) (recovery sector/substitute sector also indicated))
HD-CLEAR Use it to initialize the partition you have selected using CHK-TYPE.
Procedure
1) Select the item.
2) Press the OK key.
COPIER > FUNCTION > MISC-P
T-17-48
COPIER > FUNCTION > SENS-ADJ
T-17-49
COPIER > FUNCTION > SYSTEM
Chapter 17
Level
1
1
1
1
2
Level
2
Level
1
1
1
1
17-35