[1]
3) Attach the card reader attachment plate [1].
- Screw (RS tightening; M4X10) [2] 2pc.
[2]
4) Attach the card reader to the joint plate [1] with 1 each of the toothed
washer of the card reader and the screw (RS tightening; M4X10) [2].
5) Put the harness [1] of the card reader through the hole [2] of the card read-
er attachment plate.
[1]
6) Attach the card reader [1].
- Screw (small panhead screw; M4X6) [2] 1pc.
[2]
F-2-86
[1]
F-2-87
[2]
[1]
F-2-88
[2]
F-2-89
[1]
7) Get the cable [1] out from the side of the host machine.
If the cable is difficult to remove, drivers etc. will help make the
operation easier.
8) Connect the card reader harness with the connector [1].
[1]
9) Put the cable [1] of the card reader through the 2 clamps [2].
[1]
[2]
Chapter 2
[2]
F-2-90
[1]
F-2-91
F-2-92
F-2-93
2-23