Right Deck Lifter Motor; Before Removing The Right Deck Lifter Motor; Removing The Right Deck Lifter Motor - Canon iR5055 Series Service Manual

Chapter 8
[5] [3]
3) Remove the left deck lifter motor [2].
- 3 screws [1]
[2]

8.11.6 Right Deck Lifter Motor

8.11.6.1 Before Removing the Right Deck Lifter Motor

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Remove the charger unit (this step is necessary only for iR5075 for Japan).
(page 10-22)Reference[Removing the Charger unit]
2) Remove the rear cover (upper). (page 10-13)Reference[Removing the
Rear Cover (Upper)]
3) Remove the rear cover (lower). (page 10-13)Reference[Removing the
Rear Cover (Lower)]
4) Remove the main controller box cover.(page 10-17)Reference[Remov-
ing the Main Controller Box Cover]
5) Remove the right cover (upper rear).(page 10-12)Reference[Removing
the Right Cover (Upper Rear)]
6) Remove the main controller box. (page 4-13)Reference[Removing the
Main Controller Box]
7) Remove the right cover (lower rear). (page 10-12)Reference[Removing
the Right Cover (Lower Rear)]
8) Remove the collecting toner bottle holder. (page 5-29)Reference[Re-
moving the Collecting Toner Bottle Holder]

8.11.6.2 Removing the Right Deck Lifter Motor

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Free the harness [1] from the 9 wire saddles.
- 10 connectors
2) Remove the motor driver PCB mounting base [3].
- 4 screws [2]
8-34
[3] [4] [3]
[2] [1]
F-8-69
[1]
F-8-70
[2]
[2]
3) Free the grounding wire [2].
- 1 screw [1]
4) Disconnect the 9 connectors [3].
5) Remove the HVT PCB [5].
- 4 screws [4]
[4]
0015-4983
6) Remove the 3 screws [1].
0015-4992
7) Remove the screw [2] while sliding the cable fixing plate [1].
[3] [1]
[1]
F-8-71
[5] [3] [2] [1]
[4] [2] [3]
F-8-72
[1]
F-8-73
[2] [1]
[2]
[4]
[4]