Canon iR5055 Series Service Manual page 511

Code Description
8001 The paper pushing plate home position sensor does not go on even when
the paper pushing plate motor has been driven for 0.3 sec or more.
paper pushing plate motor (M8S), paper pushing plate home position
sensor (PI14S)
8002 The paper pushing plate home position sensor does not go off even when
the paper pushing plate motor has been driven for 80 msec.
paper pushing plate motor (M8S), paper pushing plate home position
sensor (PI14S)
8003 The number of detection pulses of the paper pushing plate motor clock
sensor is lower than a specific value.
paper pushing plate motor (M8S), paper pushing plate motor clock sensor
(PI1S)
8004 The paper pushing plate leading edge sensor does not go off even when the
paper pushing plate motor has been driven for 80 msec.
paper pushing plate motor (M8S), paper pushing plate leading edge
position sensor (PI15S)
8005 The paper pushing plate leading edge position sensor does not go on even
when the paper pushing plate has been driven for 0.3 sec or more.
paper pushing plate motor (M8S), paper pushing plate leading edge
position sensor (PI15S)
E5F9 There is a saddle switch error.
0001 With any of the sensor identifying its respective cover as being closed, the
inlet cover switch is identified as being open for 1 sec from the start of
initial rotation or printing:
- inlet cover sensor (PI9S)
- front cover open/closed sensor (PI2S)
- delivery cover sensor (PI3S)
Or, the front cover switch (MS2S) or the delivery cover switch (MS3S) is
open.
inlet cover switch (MS1S), front cover switch (MS2S), delivery cover
switch (MS3S)
0002 With any of the following sensors identifying its respective cover as being
closed, the front cover switch is identified as being open for 1 sec or more
after the start of initial rotation or printing.
- inlet cover sensor (PI9S)
- front cover open/closed sensor (PI2S)
- delivery cover sensor (PI3S)
- front cover switch (MS2S), delivery cover switch (MS3S)
0003 With any of the following sensors identifying its respective cover as being
closed, the delivery cover switch is identified as being open for 1 sec or
more from the start of initial rotation or printing:
- inlet cover sensor (PI9S)
- front cover open/closed sensor (PI2S)
- delivery cover sensor (PI3S)
- delivery cover switch (MS3S)
E602 error in hard disk or HDD encryption board
Remedy
- Check the paper pushing plate motor (M8S) and the paper pushing plate
home position sensor (PI14S).
- Check the paper pushing plate motor (M8S) and the paper pushing plate
motor clock sensor (PI1S).
- Check the paper pushing plate motor (M8S) and the paper pushing plate
leading edge position sensor (PI15S).
- Check the inlet cover switch (MS1S), front cover switch (MS2S), and the
delivery cover switch (MS3S).
- Check the front cover switch (MS2S) and the delivery cover switch
(MS3S).
- Check the delivery cover switch (MS3S).
Chapter 16
16-11