Error Code (Send) - Canon iR5055 Series Service Manual

Chapter 16
YY
10
12
14 There is a system error or a
*12
22
23
24

16.3 Error Code (SEND)

16.3.1 Results of Self-Diagnosis
iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
Cause
There is a shortage of TCP/IP resources. Try again later.
While continuous transmission is under way or has ended in FTP or
Windows (SMB), a shortage of TCP/IP resources has occurred, not
permitting reference.
Set the IP address.
The IP address of the machine has yet to be set.
The server does not respond. Check the settings.
The settings of the selected server are not correct, or the server has not been
turned on. Or, there may be a shortage of resources.
NetWare is in use. Try again later.
NetWare is printing using PSeve or NDSPServer, not permitting browsing. Wait until NetWare finishes printing; then, try again.
The layer in question at the target is too deep to browse.
The number of characters is in excess of the number allowed.
There is no response.
The server is not ready for file transmission.
The network is cut for file transmission. (An attempt to connect to the target
of transmission may have failed, or there is an open circuit in the middle.)
The tree name is not specified for NetWare transmission.
An error has occurred for TCP/IP in the course of e-mail or i-fax
transmission.
Check TCP/IP.
The machine's TCP/IP is not in operation.
The selected server cannot be found. Check the settings.
The IP address in question cannot be identified.
If the login information for the LDAP server is set to 'use (security
authentication)', the host name in question cannot be identified.
The selected server cannot be connected. Check the settings.
16-18
Description
1. Start up in safe mode; then, execute full formatting using the SST, and re-install the system software. Thereafter,
turn off and then back on the power.
2. Replace the HDD, and re-install the system software.
packet data error.
Remedy
T-16-6
Remedy
Wait a while; then, try again.
In user mode, set the IP address; thereafter, turn off and then on the machine.
Wait a while; then, try again. If browsing is still not permitted, select a different server.
The layer in question cannot be specified. Specify a different address.
Check the target.
Check the network.
Type in the tree name.
Check the condition of the network cable and the connector.
In user mode, check the TCP/IP settings (IP address, DHCP, RARP, BOOTP).
1. In user mode, check the DNS settings.
2. On the DNS side, check the DNS data settings.
In user mode, check the TCP/IP settings (DNS settings).
0015-5628