Unpacking And Installation; Unpacking And Installation Procedure; Unpacking - Canon iR5055 Series Service Manual

2.2 Unpacking and Installation

2.2.1 Unpacking and installation procedure

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
Take into account the following points when installing this equipment.
1. When transferring the host machine from a low-temperature to a warm
place and installing it, dew condensation may occur around the pickup/feed
assembly, leading to image faulty reproduction. Therefore, the host machine
is unpacked and left for 1 hour or more to make it accustom to room
temperature (Dew condensation: The phenomenon where water drops
accumulate on the surface of metal when a metal material is moved from a
low-temperature to a warm area and the moisture in the air surrounding the
metal is quickly cooled)
2. When using stairways for carrying in and out from/to the installation
space, take into account the following points.
1) When lifting the host machine, do not use the left and right grips (3
locations) but hold the four corners at the bottom of the host machine.
2) The mass of this equipment is approx. 230 kg. Make sure that four
persons perform unpacking.
3) Remove the ADF assembly, the fixing feed unit assembly and the
duplexing unit assembly, and then separate them from the host machine
before carrying in and out.

2.2.2 Unpacking

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Unpack the package, and remove the plastic bag.
2) Open the attached cardboard box, and then insert the 1 grip [1] that has
been included to the front of the pickup side.
[1]
0015-4653
0015-4654
Be sure that the leaf spring of the grip is on the right side when inserting.
Adverse insertion may cause the grip coming off while lifting the host
machine.
3) Hold the 2 grips (front/rear) on the pickup assembly side [1] of the host
machine, and then remove the 2 pads [2] while lifting the host machine a
little. (Mass of the host machine: Approx. 230 kg)
4) Hold the 2 grips (front/rear) on the delivery assembly side [1] of the host
machine, and then remove the 2 pads [2] and the the plastic bag while lift-
ing the host machine a little.
Chapter 2
F-2-6
[1]
[2]
F-2-7
2-5