D-Link xStack DES-6500 Cli Manual page 96

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config stp priority
Restrictions
Example usage:
To set the priority value for instance_id 2 as 4096:
config stp mst_config_id
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the MSTP region of the Switch with revision_level 10 and the name "Trinity":
D E S - 6 5 0 0 : 4 # c o n f i g s t p m s t _ c o n f i g _ i d r e v i s i o n _ l e v e l 1 0
n a m e T r i n i t y
C o m m a n d : c o n f i g s t p m s t _ c o n f i g _ i d r e v i s i o n _ l e v e l 1 0
n a m e T r i n i t y
instance_id <value 0-15> - Enter the value corresponding to the
previously configured instance ID of which to set the priority value. An
instance id of 0 denotes the default instance_id (CIST) internally set
on the Switch.
Only Administrator-level users can issue this command.
D E S - 6 5 0 0 : 4 # c o n f i g s t p p r i o r i t y 4 0 9 6
i n s t a n c e _ i d 2
C o m m a n d : c o n f i g s t p p r i o r i t y 4 0 9 6
i n s t a n c e _ i d 2
S u c c e s s .
D E S - 6 5 0 0 : 4 #
Used to update the MSTP configuration identification.
config stp mst_config_id {revision_level <int 0-65535> | name
<string>
This command will uniquely identify the MSTP configuration currently
configured on the Switch. Information entered here will be attached to
BDPU packets as an identifier for the MSTP region to which it
belongs. Switches having the same revision_level and name will be
considered as part of the same MSTP region.
revision_level <int 0-65535>– Enter a number between 0 and 65535
to identify the MSTP region. This value, along with the name will
identify the MSTP region configured on the Switch. The default
setting is 0.
name <string> - Enter an alphanumeric string of up to 32 characters
to uniquely identify the MSTP region on the Switch. This name, along
with the revision_level value will identify the MSTP region configured
on the Switch. If no name is entered, the default name will be the
MAC address of the device.
Only Administrator-level users can issue this command.
92