D-Link xStack DES-6500 Cli Manual page 195

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show ssh server
Restrictions
Usage example:
To display the SSH server:
D E S - 6 5 0 0 : 4 # s h o w s s h s e r v e r
C o m m a n d : s h o w s s h s e r v e r
T h e S S H s e r v e r c o n f i g u r a t i o n :
M a x S e s s i o n
C o n n e c t i o n t i m e o u t
A u t h f a i l a t t e m p t s
R e k e y t i m e o u t
S S H s e r v e r s t a t u s
L i s t e n e d P o r t N u m b e r
D E S - 6 5 0 0 : 4 #
config ssh user
Purpose
Syntax
Description
Parameters
None.
Used to configure the SSH user.
config ssh user <username 15> authmode {Hostbased
[hostname <string> | hostname_IP <string> <ipaddr>} |
Password | Publickey | None]
This command allows users to configure the SSH user
authentication method.
<username 15> - Enter a username of no more than 15 characters
to identify the SSH user.
authmode – Specifies the authentication mode of the SSH user
wishing to log on to the Switch. The administrator may choose
between:
 Hostbased – This parameter should be chosen to use a
remote SSH server for authentication purposes. Choosing this
parameter requires the user to input the following information to
identify the SSH user.
 hostname <string> - Enter an alphanumeric string of
up to 31 characters identifying the remote SSH user.
 hostname_IP
hostname and the corresponding IP address of the
SSH user.
 Password – This parameter should be chosen to use an
administrator defined password for authentication. Upon entry
of this command, the Switch will prompt the user for a
password, and then to retype the password for confirmation.
191
: 3
: 1 2 0 ( s e c )
: 2
: N e v e r
: D i s a b l e d
: 2 2
<string> <ipaddr> - Enter the