D-Link xStack DES-6500 Cli Manual page 293

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed in OSPF as the
metric 20.
Example Usage:
To add route redistribution settings:
create route redistribute dst rip src
Purpose
Syntax
Description
Parameters
Route Source
RIP
Static
Local
DES-6500:4#create route redistribute dst ospf src
rip
Command: create route redistribute dst ospf src
rip
Success.
DES-6500:4#
Used to add route redistribution settings for the exchange of OSPF
routes to RIP routes on the Switch.
create route redistribute dst rip src [local | static | ospf [all |
internal | external | extType1 | extType2 | inter+e1 | inter+e2]]
{metric <value 0-16>}
This command will redistribute routing information between the OSPF
and RIP routing protocols to all routers on the network that are
running OSPF or RIP. Routing information entered into the Static
Routing Table on the local xStack DES-6500 switch is also
redistributed
src {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2} 
Allows the selection of the protocol of the source device. The user
may choose between:

all – Specifies both internal an external.

internal – Specifies the internal protocol of the source device.

external - Specifies the external protocol of the source device.

type_1 - Calculates the metric (for RIP to OSPF) by adding the
destination's interface cost to the metric entered in the Metric
field.

type_2 - Uses the metric entered in the Metric field without
change. This field applies only when the destination field is
OSPF.

inter+e1 – Specifies the internal protocol AND type 1 of the
external protocol.

inter+e2 – Specifies the internal protocol AND type 2 of the
external protocol.
metric <value 0-16>  Allows the entry of an OSPF interface cost.
Metric
0 to 16777214
0 to 16777214
0 to 16777214
289
Metric Type
mettype 1
mettype 2
mettype 1
mettype 2
mettype 1
mettype 2