D-Link xStack DES-6500 Cli Manual page 136

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config vlan delete
Restrictions
Example usage:
To delete ports 5-7 of module 2 of the VLAN v1:
D E S - 6 5 0 0 : 4 # c o n f i g v l a n v 1 d e l e t e 2 : 5 - 2 : 7
C o m m a n d : c o n f i g v l a n v 1 d e l e t e 2 : 5 - 2 : 7
S u c c e s s .
D E S - 6 5 0 0 : 4 #
config gvrp
Purpose
Syntax
Description
Parameters
<portlist>  A range of ports to delete from the VLAN. The port list is
specified by listing the lowest line card number and the beginning port
number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also separated
by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies line card number
1, port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4 specifies all
of the ports between line card 1, port 3 and line card 2, port 4  in
numerical order.
Only Administrator-level users can issue this command.
Used to configure GVRP on the Switch.
config gvrp [<portlist> | all] {state [enabled | disabled] |
ingress_checking [enabled | disabled] | acceptable_frame
[tagged_only | admit_all] | pvid <vlanid 1-4094>}
This command is used to configure the Group VLAN Registration
Protocol on the Switch. Configurable items include ingress checking,
the sending and receiving of GVRP information, and the Port VLAN ID
(PVID).
<portlist>  A range of ports for which to configure GVRP. The port list
is specified by listing the lowest line card number and the beginning
port number on that line card, separated by a colon. Then the highest
line card number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies line card
number 1, port 3. 2:4 specifies line card number 2, port 4. 1:3-2:4
specifies all of the ports between line card 1, port 3 and line card 2, port
4  in numerical order.
all  Specifies all of the ports on the Switch.
state [enabled | disabled]  Enables or disables GVRP for the ports
specified in the port list.
ingress_checking [enabled | disabled]  Enables or disables ingress
checking for the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states the
frame type that will be accepted by the Switch for this function.
Tagged_only implies that only VLAN tagged frames will be accepted,
while admit_all implies tagged and untagged frames will be accepted
132