D-Link xStack DES-6500 Cli Manual page 40

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Command
config snmp engineID
show snmp engineID
create snmp group
delete snmp group
show snmp groups
create snmp host
delete snmp host
show snmp host
create trusted_host
delete trusted_host
show trusted_host
enable snmp traps
enable snmp authenticate_traps
show snmp traps
disable snmp traps
disable snmp authenticate_traps
config snmp system contact
config snmp system location
config snmp system name
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Syntax
Description
Parameters
<snmp_engineID>
<groupname 32> {v1 | v2c | v3 [noauth_nopriv |
auth_nopriv | auth_priv]} {read_view <view_name 32> |
write_view <view_name 32> | notify_view <view_name
32>}
<groupname 32>
<ipaddr> {v1 |v2c | v3 [noauth_nopriv | auth_nopriv |
auth_priv]} <auth_string 32>
<ipaddr> <auth_string 32>
{<ipaddr>}
<ipaddr>
<ipaddr>
{<ipaddr>}
<sw_contact>
<sw_location>
<sw_name>
Used to create a new SNMP user and adds the user to an SNMP
group that is also created by this command.
create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
The create snmp user command creates a new SNMP user and
adds the user to an SNMP group that is also created by this
command. SNMP ensures:
Message integrity  Ensures that packets have not been tampered
with during transit.
Authentication  Determines if an SNMP message is from a valid
36