D-Link xStack DES-6500 Cli Manual page 264

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
T o t a l E n t r i e s : 3
D E S - 6 5 0 0 : 4 #
reconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To connect to the MS, with member ID 2, through the CS, using the command line interface:
D E S - 6 5 0 0 : 4 # r e c o n f i g m e m b e r _ i d 2
C o m m a n d : r e c o n f i g m e m b e r _ i d 2
D E S - 6 5 0 0 : 4 #
config sim_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add a member:
D E S - 6 5 0 0 : 4 # c o n f i g s i m _ g r o u p a d d 2
C o m m a n d : c o n f i g s i m _ g r o u p a d d 2
Used to connect to a member switch, through the commander switch using
telnet.
reconfig [member_id <value 1-32> | exit]
This command is used to reconnect to a member switch using Telnet.
member_id <value 1-32> - Select the ID number of the member switch to
configure.
exit – This command is used to exit from managing the member switch and will
return to managing the commander switch.
Only Administrator-level users can issue this command.
Used to add candidates and delete members from the SIM group.
config sim_group [add <candidate_id 1-100> {<password>} | delete
<member_id 1-32>]
This command is used to add candidates and delete members from the
SIM group by ID number.
add <candidate_id 1-100> <password> - Use this parameter to change a
candidate switch (CaS) to a member switch (MS) of a SIM group. The CaS
may be defined by its ID number and a password (if necessary).
delete <member_id 1-32> - Use this parameter to delete a member switch
of a SIM group. The member switch should be defined by it ID number.
Only Administrator-level users can issue this command.
260