D-Link xStack DES-6500 Cli Manual page 223

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
P o r t n u m b e r : 1 : 1 6
E n t e r s C o n n e c t i n g
E a p L o g o f f s W h i l e C o n n e c t i n g
E n t e r s A u t h e n t i c a t i n g
S u c c e s s W h i l e A u t h e n t i c a t i n g
T i m e o u t s W h i l e A u t h e n t i c a t i n g
F a i l W h i l e A u t h e n t i c a t i n g
R e a u t h s W h i l e A u t h e n t i c a t i n g
E a p S t a r t s W h i l e A u t h e n t i c a t i n g
E a p L o g o f f W h i l e A u t h e n t i c a t i n g
R e a u t h s W h i l e A u t h e n t i c a t e d
E a p S t a r t s W h i l e A u t h e n t i c a t e d
E a p L o g o f f W h i l e A u t h e n t i c a t e d
B a c k e n d R e s p o n s e s
B a c k e n d A c c e s s C h a l l e n g e s
B a c k e n d O t h e r R e q u e s t s T o S u p p l i c a n t
B a c k e n d N o n N a k R e s p o n s e s F r o m S u p p l i c a n t
B a c k e n d A u t h S u c c e s s e s
B a c k e n d A u t h F a i l s
C T R L + C E S C q Q u i t S P A C E n N e x t P a g e E n t e r N e x t E n t r y a A l l
show auth_session_statistics
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current authentication session statistics for port 16:
Used to display the current authentication session statistics.
show auth_session_statistics {ports [<portlist> | all]}
The show auth_session statistics command is used to display
the current authentication session statistics of the Switch on a per
port basis.
ports <portlist>  Specifies a range of ports. The port list is
specified by listing the lowest line card number and the beginning
port number on that line card, separated by a colon. Then the
highest line card number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
of the port list range are separated by a dash. For example, 1:3
specifies line card number 1, port 3. 2:4 specifies line card number
2, port 4. 1:3-2:4 specifies all of the ports between line card 1, port
3 and line card 2, port 4  in numerical order.
all – Specifies that all ports will be viewed.
None.
219
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0