D-Link xStack DES-6500 Cli Manual page 323

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config pim crp
Restrictions
Usage example:
To configure the Candidate RP settings for the multiple access network:
DES-6500:4#config pim crp holdtime 150 priority 2
wildcard_prefix_cnt 0
Command: config pim crp holdtime 150 priority 2
wildcard_prefix_cnt 0
Success.
DES-6500:4#
create pim static_rp
Purpose
Syntax
Description
Parameters
Restrictions
Usage example:
To create the settings to determine a static RP:
DES-6500:4#create pim static_rp group 231.0.0.1/32 rp
11.1.1.1
Command: create pim static_rp group 231.0.0.1/32 rp
11.1.1.1
Success.
DES-6500:4#
wildcard_prefix_cnt [0 | 1] - The user may set the Prefix Count value of
the wildcard group address here by choosing a value between 0 and 1
with a default setting of 0.
Only Administrator-level users can issue this command.
Used to enter the multicast group IP address used in identifying the
Rendezvous Point (RP).
create pim static_rp group <ip_addr/netmask> rp <ipaddr>
This command will enter the multicast group IP address which will be
used to identify the RP. This entry must be a class D IP address. This
command is for PIM-SM configurations only.
group <ip_addr/netmask> - Enter the multicast group IP address used
in determining the Static RP. This address must be a class D IP
address.
rp <ipaddr> - Enter the IP address of the RP the switch administrator
wishes to become the Static RP for this group.
Only Administrator-level users can issue this command.
319