D-Link xStack DES-6500 Cli Manual page 286

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show vrrp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the global VRRP settings currently implemented on the Switch (VRRP Enabled):
DES-6500:4#show vrrp
Command: show vrrp
Global VRRP
Non-owner response PING : Disabled
Interface Name
Authentication type
Total Entries :
DES-6500:4#
delete vrrp
Purpose
Syntax
Description
Parameters
To view the VRRP settings set on the Switch.
show vrrp ipif {ipif <ipif_name 12> {vrid <vrid 1-255>}}
This command is used to view current VRRP settings of the VRRP
Operations table.
ipif <ipif_name 12> - Enter the name of a previously configured IP
interface for which to view the VRRP settings. This IP interface must
be assigned to a VLAN on the Switch.
vrid <vrid 1-255> - Enter the VRRP ID of a VRRP entry for which to
view these settings.
Only Administrator-level users can issue this command.
VRID
Virtual IP Address
Virtual MAC Address
Virtual Router State : Master
State
Priority
Master IP Address
Critical IP Address
Checking Critical IP : Disabled
Advertisement Interval : 1 secs
Preempt Mode
Virtual Router Up Time : 2754089 centi-secs
1
Used to delete a vrrp entry from the switch.
delete vrrp [all|vrid <vrid 1-255> ipif <ipif_name 12>]
This command is used to remove a VRRP router running on a local
device.
vrid <vrid 1-255> - Enter the VRRP ID of the virtual router to be
deleted. Not entering this parameter will delete all VRRP entries on
the Switch.
282
:Enabled
: System
: No Authentication
: 2
: 10.53.13.3
: 00-00-5E-00-01-02
: Enabled
: 255
: 10.53.13.3
: 0.0.0.0
: True