Ipv4 Multicast Static Route List - D-Link xStack DES-6500 Cli Manual

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
The IPv4 Multicast Static Route commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create ipmroute
delete ipmroute
show ipmroute
Each command is listed, in detail, in the following sections.
create ipmroute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To create an IP multicast static route entry:
DES-6500:4# create ipmroute 11.0.0.0/8 rpf_address
20.1.1.1
Command: create ipmroute 11.0.0.0/8 rpf_address
20.1.1.1
Success.
DES-6500:4#
IP 4 M
V
Parameters
<network_address> rpf_address [<ipaddr> | null]
[<network_address>|all]
{<network_address>}
Used to create an ip multicast static route configuration entry.
create ipmroute <network_address> rpf_address [<ipaddr> | null]
Normally, when an IP multicast packet is received, the source IP
address of the packet is used to do the RPF check. When an RPF
network is configured for the network, if the source IP address of the
received IP multicast packet matches this network, the RPF network
will be used to do RPF check.
network address - if the source IP address of the received IP multicast
packet matches this network, the RPF network is used to do RPF
check.
ipaddr - It specifies an ip address, if the source IP address of the
received IP multicast packet matches the network_address, ipaddr will
be used to check whether packets are received from a legal upstream
interface. If it is set to null, it means that if the source IP address in the
received IP multicast packet matches the network_address, the RPF
check will always fail.
Only Administrator-level users can issue this command.
S
ULTICAST
355
42
R
TATIC OUTE
L
IST