D-Link xStack DES-6500 Cli Manual page 66

Modular layer 3 chassis ethernet switch
Hide thumbs Also See for xStack DES-6500:
Table of Contents

Advertisement

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
traceroute
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To trace the routed path between the Switch and 10.48.74.121.
D E S - 6 5 0 0 : 4 # t r a c e r o u t e 1 0 . 4 8 . 7 4 . 1 2 1 p r o b e 3
C o m m a n d : t r a c e r o u t e 1 0 . 4 8 . 7 4 . 1 2 1 p r o b e 3
1
2
3
D E S - 6 5 0 0 : 4 #
enable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Used to trace the routed path between the Switch and a destination
endstation.
<ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout <sec
1-65535> | probe <value <1-9>}
The traceroute command users to trace a route between the Switch and
a give host on the network.
<ipaddr> - Specifies the IP address of the host.
ttl <value 1-60> - The time to live value of the trace route request. This is
the maximum number of routers the traceroute command will cross while
seeking the network path between two devices.
port <value 30000-64900> - The port number. Must be above 1024.The
value range is from 30000 to 64900.
timeout <sec 1-65535> - Defines the time-out period while waiting for a
response from the remote device. The user may choose an entry
between 1 and 65535 seconds.
probe <value 1-9> - The probe value is the number of times the Switch
will send probe packets to the next hop on the intended traceroute path.
The default is 1.
None.
< 1 0 m s 1 0 . 2 5 4 . 2 5 4 . 2 5 1
< 1 0 m s 1 0 . 5 5 . 2 5 . 3 5
< 1 0 m s 1 0 . 2 2 . 3 5 . 1
Used to activate the autoconfiguration function for the Switch. This will load a
previously saved configuration file for current use.
enable autoconfig
When autoconfig is enabled on the Switch, the DHCP reply will contain a
configuration file and path name. It will then request the file from the TFTP
server specified in the reply. When autoconfig is enabled, the ipif settings will
automatically become DHCP client.
None.
When autoconfig is enabled, the Switch becomes a DHCP client automatically
62

Advertisement

Table of Contents
loading

Table of Contents