D-Link xStack DES-6500 Cli Manual page 117

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config bandwidth_control
Restrictions
Example usage:
To configure bandwidth control:
D E S - 6 5 0 0 : 4 # c o n f i g b a n d w i d t h _ c o n t r o l 1 : 1 - 1 : 1 0
t x _ r a t e 1 0
C o m m a n d : c o n f i g b a n d w i d t h _ c o n t r o l 1 : 1 - 1 : 1 0 t x _ r a t e
1 0
S u c c e s s .
D E S - 6 5 0 0 : 4 #
show bandwidth_control
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display bandwidth control settings:
D E S - 6 5 0 0 : 4 # s h o w b a n d w i d t h _ c o n t r o l 1 : 1 - 1 : 1 0
C o m m a n d : s h o w b a n d w i d t h _ c o n t r o l 1 : 1 - 1 : 1 0
B a n d w i d t h C o n t r o l T a b l e
P o r t
packets transmitted by the above specified ports.
 <value 1-9999>  Specifies the packet limit, in Mbps, that the
above ports will be allowed to transmit.
Only Administrator-level users can issue this command.
Used to display the bandwidth control configuration on the Switch.
show bandwidth_control {<portlist>}
The show bandwidth_control command displays the current
bandwidth control configuration on the Switch, on a port-by-port basis.
<portlist>  Specifies a range of ports to be displayed. The port list is
specified by listing the lowest line card number and the beginning port
number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies line
card number 1, port 3. 2:4 specifies line card number 2, port 4. 1:3-
2:4 specifies all of the ports between line card 1, port 3 and line card
2, port 4  in numerical order.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
None.
R X R a t e ( M b i t / s e c ) T X _ R A T E ( M b i t / s e c )
113