D-Link xStack DES-6500 Cli Manual page 132

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
create vlan
tag <vlanid 2-4094>  The VLAN ID of the VLAN to be created.
Allowed values = 2-4094
type – This parameter uses the type field of the packet header to
determine the packet protocol and destination VLAN. There are two
main choices of types for VLANs created on the Switch:
The following parameters allow for the creation of protocol-based
VLANs. The Switch supports 15 pre-configured protocol-based VLANs
plus one user defined protocol based VLAN where the administrator
may configure the settings for the appropriate protocol and forwarding
of packets (16 total). Selecting a specific protocol will indicate which
protocol will be utilized in determining the VLAN ownership of a
tagged packet. Pre-set protocol-based VLANs on the Switch include:
 1q_vlan – Allows the creation of a normal 802.1Q VLAN on
the Switch.
 advertisement 
Specifies that the VLAN is able to join
GVRP. If this parameter is not set, the VLAN cannot be
configured to have forbidden ports.
 protocol-ip – Using this parameter will instruct the Switch to
forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
based on the Ethernet protocol.
 protocol-ipx802dot3 - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by Novell NetWare 802.3 (IPX - Internet
Packet Exchange).
 protocol-ipx802dot2 - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by Novell NetWare 802.2 (IPX - Internet
Packet Exchange).
 protocol-ipxSnap - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by Novell and the Sub Network Access
Protocol (SNAP).
 protocol-ipxEthernet2 - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by Novell Ethernet II Protocol.
 protocol-appleTalk - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
information is defined by the AppleTalk protocol.
 protocol-decLAT - Using this parameter will instruct the Switch
to forward packets to this VLAN if the tag in the packet header is
concurrent with this protocol. This packet header information is
defined by the Digital Equipment Corporation (DEC) Local Area
Transport (LAT) protocol.
 protocol–sna802dot2 - Using this parameter will instruct the
Switch to forward packets to this VLAN if the tag in the packet
header is concurrent with this protocol. This packet header
128