D-Link xStack DES-6500 Cli Manual page 159

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config igmp_snooping querier
Restrictions
Example usage:
To configure the IGMP snooping querier:
D E S - 6 5 0 0 : 4 # c o n f i g i g m p _ s n o o p i n g q u e r i e r d e f a u l t q u e r y _ i n t e r v a l
1 2 5 s t a t e e n a b l e d
C o m m a n d : c o n f i g i g m p _ s n o o p i n g q u e r i e r d e f a u l t q u e r y _ i n t e r v a l
1 2 5 s t a t e e n a b l e d
S u c c e s s .
D E S - 6 5 0 0 : 4 #
enable igmp_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable IGMP snooping on the Switch:
D E S - 6 5 0 0 : 4 # e n a b l e i g m p _ s n o o p i n g
C o m m a n d : e n a b l e i g m p _ s n o o p i n g
S u c c e s s .
DES-6500:4#

By default, the robustness variable is set to 2. You might want
to increase this value if you expect a subnet to be lossy.
last_member_query_interval <sec 1-25>  The maximum amount of
time between group-specific query messages, including those sent in
response to leave-group messages. Lower this interval to reduce the
amount of time it takes a router to detect the loss of the last member of
a group.
state [enabled | disabled]  Allows the Switch to be specified as an
IGMP Querier or Non-querier.
Only Administrator-level users can issue this command.
Used to enable IGMP snooping on the Switch.
enable igmp_snooping {forward_mcrouter_only}
This command allows you to enable IGMP snooping on the Switch. If
forward_mcrouter_only is specified, the Switch will only forward all
multicast traffic to the multicast router, only. Otherwise, the Switch
forwards all multicast traffic to any IP router.
forward_mcrouter_only  Specifies that the Switch should only forward
all multicast traffic to a multicast-enabled router. Otherwise, the Switch
will forward all multicast traffic to any IP router.
Only Administrator-level users can issue this command.
155