D-Link xStack DES-6500 Cli Manual page 143

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port
9:
group _id <value 1-32>  Specifies the group ID. The Switch allows up
to 32 link aggregation groups to be configured. The group number
identifies each of the groups.
master_port <port>  Master port ID. Specifies which port (by port
number) of the link aggregation group will be the master port. All of the
ports in a link aggregation group will share the port configuration with
the master port. The port is specified by listing the lowest line card
number and the beginning port number on that line card, separated by
a colon. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4.
ports <portlist>  Specifies a range of ports that will belong to the link
aggregation group. The port list is specified by listing the lowest line
card number and the beginning port number on that line card,
separated by a colon. Then the highest line card number, and the
highest port number of the range (also separated by a colon) are
specified. The beginning and end of the port list range are separated
by a dash. For example, 1:3 specifies line card number 1, port 3. 2:4
specifies line card number 2, port 4. 1:3-2:4 specifies all of the ports
between line card 1, port 3 and line card 2, port 4  in numerical order.
state [enabled | disabled]  Allows the user to enable or disable the
specified link aggregation group.
Only Administrator-level users can issue this command. Link
aggregation groups may not overlap.
139