D-Link xStack DES-6500 Cli Manual page 145

xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current Link Aggregation configuration:
D E S - 6 5 0 0 : 4 # s h o w l i n k _ a g g r e g a t i o n
C o m m a n d : s h o w l i n k _ a g g r e g a t i o n
L i n k A g g r e g a t i o n A l g o r i t h m = M A C - s o u r c e - d e s t
G r o u p I D
M a s t e r P o r t
M e m b e r P o r t
A c t i v e P o r t :
S t a t u s
F l o o d i n g P o r t
D E S - 6 5 0 0 : 4
config lacp_port
Purpose
Syntax
Description
Parameters
Used to display the current link aggregation configuration on the
Switch.
show link_aggregation {group_id <value 1-32> | algorithm}
This command will display the current link aggregation configuration
of the Switch.
<value 1-32>  Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number
identifies each of the groups.
algorithm  Specify to view the algorithm employed of this link
aggregation group.
None.
: 1
: 2 : 1 7
: 1 : 5 - 1 : 1 0 , 2 : 1 7
: D i s a b l e d
: 1 : 5
Used to configure settings for LACP compliant ports.
config lacp_port <portlist> mode [active | passive]
This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
<portlist>  Specifies a range of ports to be configured. The port list is
specified by listing the lowest line card number and the beginning port
number on that line card, separated by a colon. Then the highest line
card number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies line
card number 1, port 3. 2:4 specifies line card number 2, port 4. 1:3-
2:4 specifies all of the ports between line card 1, port 3 and line card
2, port 4  in numerical order.
141