Table of Contents
Advertisement
Using the special spanner, bring the eccentric back
into position by rotating in an anti-clockwise direction to
tighten the chain.
Special tool:
Spanner for eccentric hub
Extension for spanner
Tighten the wheel pin fixing nut by rotating it clockwise
as shown in the figure, by using the following tools:
• Torque wrench
• 55 mm polygonal socket wrench
Slip flange nut coupling torque:
200 ÷ 220 N·m
Apply grease only on the threaded part
Assemble the retaining ring (1).
Rear wheel assembly
In the case of substitution of the rear tyre it
will be necessary to effectuate the balancing
of the wheel before assembling it. Follow the
instructions indicated in page 68.
Insert 1st gear. Reassemble the rear wheel.
Tighten the wheel axis nut to the prescribed torque
pressure.
Torque pressure: 220 ÷ 240 N·m
Apply grease only on the threaded part
Insert the retaining ring (1).
At the end of the re-assembly procedure, restore the
tension in the chain.
Suspension and wheels
N. 800092854
N. 800092855
- 61 -
200÷220 N•m
220÷240 N•m
F
1
Advertisement
Table of Contents
