Table of Contents
Advertisement
Remove the 2 screws indicated in the figure and take
off the caliper.
Remove the fitting to disconnect the caliper.
For caliper reassembly, tighten the two screws to the
prescribed torque pressure.
Recommended threadlocking product:
Loctite 243
Torque pressure: 18 N·m
Assemble the union tightening to the prescribed
torque.
Torque pressure: 23 ÷ 26 N·m
NOTE
Substitute the gaskets with new ones.
Proceed with the filling and bleeding of the rear brake
H
system (see page 23).
Brakes
23÷26 N•m
- 26 -
18 N•m
Advertisement
Table of Contents
