MV Agusta Rivale 800 Workshop Manual page 65

To remove the stand, follow these steps:
- after having removed the kickstand switch, remove
the screw (3);
- remove screw (4).
To refit the stand, follow the same steps in reverse
order, taking care to tighten the screws to the pre-
scribed torque.
Tightening torque for stand plate screws:
40 ÷ 44 N·m
Apply Loctite 243
To disassemble the side stand of the plate, proceed as
follows:
- place the whole stand in a vice grip as shown in the
figure;
Maintenance
- 49 -
3
4
B
40÷44 N•m