MV Agusta Rivale 800 Workshop Manual page 391

Hide thumbs Also See for Rivale 800:

Table of Contents

Check the thickness of the rear brake disc by utilising

a micrometer gauge and measuring at least at three

points with 120° between them.

The minimum thickness of the disc must not be less

than 4.7 mm.

Utilise a micrometer gauge for this check.

Before fitting the rear brake disc, check the condition of

the four pins.

Replace the four special nuts with new ones.

Proceed with tightening of the nuts.

Turn in the nuts until they make contact,

then tighten them in a crosswise pattern.

Torque pressure: 18÷20 N·m.

Conclude the reassembly operations of the various

components by following the procedures previously

described in the chapter.

Use the following tightening torque to reassemble the

phonic wheel:

Torque pressure: 3 N·m

threadlocking

threadlocking