MV Agusta Rivale 800 Workshop Manual page 336

Protect the air intake lines using adhesive tape in order
to avoid dirt from getting into the cylinders.
For reassembly proceed the opposite order as disas-
sembly, applying the following procedure to tighten the
throttle body screws:
- Tighten the 6 fixing screws of the throttle body at a
tightening torque of 10 Nm, respecting the tightening
G sequence shown in the figure.
- Loosen the 6 fixing screws in the opposite order.
- Tighten the 6 fixing screws of the throttle body once
again at a tightening torque of 10 Nm, respecting the
tightening sequence shown in the figure.
Remove the following components in order:
- Steering head
- Handlebar
- Right/left front forks
- Steering base
as described in chapter F - "Suspension and Wheels".
Frame
6
4
- 22 -
1
3
2
5