Tilt Sensor - MV Agusta Rivale 800 Workshop Manual

• Disconnect the cables (1) of the starter motor and
the positive cable of the battery from the relay .
E
Apply 12 volts to the terminals (1) and (2) of the relay
and check the continuity between terminals B-M.
Do not apply the battery voltage to the starter
relay for more than five seconds to avoid
overheating and therefore damaging the
winding.
• Using a multi-tester, check that the winding is on
open circuit or if a resistance is present. The wind-
ing is in good condition if the value of the resistance
revealed is as indicated.
Multi-tester dial indication: ohm Ω
Starter relay resistance
Standard: 5 Ohm ±10% 20°C

TILT SENSOR

The fall sensor (1) acts on the engine control unit, inter-
rupting power when a vehicle tilt of more than 60°± 10°
for more than 3 seconds.
Electrical system
1
- 22 -
1