Table of Contents
Advertisement
INJECTOR CHECK
To check the injectors proceed as follows:
- Disconnect the connector on each injector.
- Proceed with checking the reel of each injector
- The contact must not be open between the two pins
of the injector, also, the resistance value must be 11
Ohm ±10% at 20°C.
Otherwise, proceed with changing the faulty injector.
FUEL PUMP CHECK
Check the condition of the fuel pump fuse.
To check the condition of the fuel pump, proceed as fol-
lows:
- After having removed the fuel tank, proceed with the
check of continuity between pin 2 and 5 on the con-
nector of the pump as indicated in the figure.
- proceed with checking the level probe operation
- connect pins 3 and 4 of the pump connector and
make sure that the resistance value is 2 kOhm ±10%
at 20°C
Air intake injection system
- 11 -
D
Advertisement
Table of Contents
