Table Of Lubricants And Fluids; Engine Oil And Oil Filter; Maintenance And Tuning Operations - MV Agusta Rivale 800 Workshop Manual

Table of lubricants and fluids

Description
Engine oil
Engine coolant
B
Brake and clutch fluid
Chain lubrication oil
* : To find the recommended product, MV Agusta suggests going directly to the authorised MV Agusta dealers.
Eni i-Ride moto2 5W/40 has been manufactured for the Rivale 800 engine. If the described oil is not available,
MV Agusta suggests using completely synthetic oils with characteristics equal or better than
the ones prescribed in the following standards:
– Conforming to
– Conforming to
– Conforming to
– Grade
The above specifications indicated are marked either on their own or together
NOTE
with others on the container of the lubricating oil.

MAINTENANCE AND TUNING OPERATIONS

Each operation of periodical maintenance is described
in this chapter.

ENGINE OIL AND OIL FILTER

Engine oil
Substitute:→ at the first 1000 kilometres and then
every 6000 kilometres.
Oil filter
Substitute:→ at the first 1000 kilometres and then
every 6000 kilometres (or at least
every oil change).
To accede to the oil filter and the discharge and filling
holes of the engine oil, it is necessary to carry out cer-
tain operations beforehand:
Position the motorcycle on the rear stand.
n
The substitution of the engine oil must be
NOTE
done with a hot engine as opposed to the
oil-check that is done with a cold engine.
Remove filler cap (1) on the rh side of the vehicle so
allow the oil to drain out (see figure).
To remove the filler cap, unscrew it anticlockwise.
Maintenance
Recommended product
eni i-Ride moto2 5W-40 ( * )
AGIP ECO - PERMANENT
D.I.D. CHAIN LUBE
API SL
ACEA A3
JASO MA, MA2
SAE 5W-40
Agip Brake 4
- 8 -
Specifications
SAE 5W/40 - API SL
Ethylene-glycol
diluted with
50% distilled water
DOT4
–
Engine oil
SAE 5W-40
API SL
ACEA A3
JASO MA, MA2
1