Footpeg, Heel Guard And Mount: Firebolt/Lightning; Rider; Wear Peg Removal; Footpeg Removal - Buell XB 2008 Series Service Manual

FOOTPEG, HEEL GUARD AND MOUNT:
FIREBOLT/LIGHTNING

RIDER

Wear Peg Removal

1. See Figure 2-155. Remove wear peg (7) from end of
footpeg assembly.

Footpeg Removal

1. See Figure 2-155. Remove clip (5).
2. Remove footpeg pin (9).
3. Remove footpeg (8).

Heel Guard Removal

1. See Figure 2-155. Remove heel guard fasteners (4).
2. Remove heel guard (3).

Mount Removal

1. See Figure 2-155. Remove footpeg mount fasteners (2).
2. Remove footpeg mount (1).

Mount Installation

1. See Figure 2-155. Position footpeg mount (1).
2. Install footpeg mount with fasteners (2). Tighten to 132-
144 in-lbs (14.9-16.2 Nm).

Heel Guard Installation

1. See Figure 2-155. Position heel guard (3) onto footpeg
mount (1).
There is one long fastener which installs on the lower left side
in order to secure the non-California vent clamp.
2. Install heel guard (3) with fasteners (4). Tighten to 72-96
in-lbs (8-11 Nm).

Footpeg Installation

1. See Figure 2-155. Position spring (6) in footpeg (8).
2. Position footpeg (8) and spring in footpeg mount (1).
3. Install footpeg pin (9).
4. Install clip (5).

Wear Peg Installation

1. See Figure 2-155. Apply LOCTITE 271 (red) and tighten
to 36-48 in-lbs (4-5 Nm).
NOTE
sm03637
2
3
5
4
7
1. Footpeg mount
2. Footpeg mount fasteners
3. Heel guard
4. Heel guard fasteners
5. Clip, footpeg
6. Spring
7. Wear peg
8. Footpeg
9. Pin
Figure 2-155. Rider Footpeg, Mount and Heel Guard:
Firebolt/Lightning

PASSENGER

Footpeg Removal
1. See Figure 2-156. Remove clip (7).
2. Remove footpeg pin (9).
3. Remove footpeg (8), detent plate (6), ball (5) and spring
(4).
Heel Guard Removal
1. See Figure 2-156. Remove heel guard fasteners (1).
2. Remove heel guard (2).
Mount Removal
1. See Figure 2-156. Remove footpeg mount fasteners (10).
2. Remove footpeg mount (3).
2008 XB Service: Chassis 2-107
2.36
1
9
6
8