Authenticator State - D-Link DGS-3600 Series User Manual

The following windows are used to monitor 802.1x statistics of the Switch, on a per port basis. To view the Port Access Control
windows, open the monitoring folder and click the Port Access Control folder. There are six windows to monitor.

Authenticator State

The following section describes the 802.1x Status on the Switch. To view the Authenticator State, click Monitoring > Port
Access Control > Authenticator State.
This window displays the Authenticator State for individual ports on a selected device. A polling interval between 1 and 60
seconds can be set using the drop-down menu at the top of the window and clicking OK.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
NOTE: The Authenticator State cannot be viewed on the Switch unless
802.1X is enabled by port or by MAC address. To enable 802.1x, go to the
DGS-3600 Web Management Tool window.
Figure 12- 2 . Authenticator State window (Port-based 802.1x) 0
326