Ex9200-40F-M Line Card - Juniper EX9214 Hardware Manual

The ports labeled 0/0 through 0/9 form pic 0 and the ports labeled 1/0 through 1/9 form pic 1. The
ports labeled 2/0 through 2/9 form pic 2 and the ports labeled 3/0 through 3/9 form pic 3.

EX9200-40F-M Line Card

IN THIS SECTION
Line Card Models | 105
Line Card Components | 106
The line cards in EX9200 switches combine a Packet Forwarding Engine and Ethernet interfaces in a
single assembly. Line cards are field-replaceable units (FRUs) that you can install in the line card slots on
the front of the switch chassis. Line cards are hot-insertable and hot-removable: You can remove and
replace them without powering off the switch or disrupting switch functions.
Line Card Models
Table 37 on page 105 shows the model number, description of the line card model, and the Junos OS
release in which the line card was first supported.
Table 37: EX9200-40F-M Line Card
Model Description
EX9200-40F-M A line card with 40 1-Gigabit Ethernet ports with Media Access Control
Security (MACsec) capability, each of which can house 1-gigabit small form-
factor pluggable (SFP) transceivers. The EX9200-40F-M line card supports
802.1AE IEEE MAC Security standard (also known as MACsec) with
AES-128 bit encryption, providing support for link-layer data confidentiality,
data integrity, and data origin authentication. You must apply a single license
—EX9200-SFL—to enable MACsec.
105
Junos OS
Release
Required
14.2R1 or later