Switch Fabric Module Leds In An Ex9200 Switch; Ex9200-Sf3 Module In An Ex9200 Switch - Juniper EX9214 Hardware Manual

Switch Fabric Module LEDs in an EX9200 Switch

The Switch Fabric module (SF module) has three LEDs on the module faceplate.
describes the functions of these LEDs. For information about the LEDs on the EX9200-SF3, see
24 on page 71.
Table 24: SF Module LEDs of an EX9200 Switch
LED Status
FABRIC ACTIVE Green
Unlit
FABRIC ONLY Green
Unlit
OK/FAIL Green
Red
Unlit
The BITS, GPS, and UTI LEDs, located next to the EXT CLK port, indicate the status of the respective
clocking interface. These LEDs are not supported.

EX9200-SF3 Module in an EX9200 Switch

IN THIS SECTION
EX9200-SF3 Components and Features | 74
EX9200-SF3 LEDs | 75
Description
Switch Fabric is in active mode.
Switch Fabric is offline.
On steadily—Switch Fabric is operating in fabric-only
mode.
Switch Fabric is not operating in fabric-only mode.
Switch Fabric is online.
Switch Fabric has failed.
Switch Fabric is offline.
Table 24 on page 71
Table
71