Connecting And Configuring An Ex9200 Switch (Cli Procedure) - Juniper EX9214 Hardware Manual

messages, while also enabling the Link Layer Discovery Protocol (LLDP) protocol, the Rapid Spanning
Tree Protocol (RSTP), Internet Group Management Protocol (IGMP) snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that becomes the
active configuration. You can always revert to the factory default configuration. See
Default Factory Configuration for the EX Series Switch
This topic shows the factory default configuration file of an EX9200 switch.
system {
arp {
aging-timer 5;
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
file interactive-commands {
interactive-commands any;
}
}
}
protocols {
lldp {
interface all;
}
}

Connecting and Configuring an EX9200 Switch (CLI Procedure)

The EX9200 switch is shipped with the Junos OS preinstalled and ready to be configured when the
switch is powered on. There are three copies of the software: one on a CompactFlash card in the
Routing Engine module (RE module), one on a rotating hard disk in the RE module, and one on a USB
flash drive that can be inserted into the slot in the faceplate of the RE module.
.
Reverting to the
195