Ftp - ZyXEL Communications NXC2500 User Manual

Table 163 Configuration > System > TELNET (continued)
LABEL
Apply
Reset

28.10 FTP

You can upload and download the NXC's firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See
about firmware and configuration files.
To change your NXC's FTP settings, click Configuration > System > FTP tab. The screen appears
as shown. Use this screen to specify from which zones FTP can be used to access the NXC. You can
also specify from which IP addresses the access can come.
Figure 189 Configuration > System > FTP
The following table describes the labels in this screen.
Table 164 Configuration > System > FTP
LABEL
Enable
TLS required
Server Port
Server
Certificate
Service Control
Chapter 28 System
DESCRIPTION
Click Apply to save your changes back to the NXC.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the NXC using this service.
Select the check box to use FTP over TLS (Transport Layer Security) to encrypt
communication.
This implements TLS as a security mechanism to secure FTP clients and/or servers.
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Select the certificate whose corresponding private key is to be used to identify the NXC for
FTP connections. You must have certificates already configured in the My Certificates
screen.
This specifies from which computers you can access which NXC zones.
NXC Series User's Guide
Chapter 30 on page 343
318
for more information