ZyXEL Communications NXC2500 User Manual page 394

Table 199 Built-in Services Logs (continued)
LOG MESSAGE
HTTP port has changed
to default port.
SSH port has been
changed to port %s.
SSH port has been
changed to default
port.
SSH certificate:%s
does not exist. SSH
service will not work.
SSH certificate:%s
format is wrong. SSH
service will not work.
TELNET port has been
changed to port %s.
TELNET port has been
changed to default
port.
FTP certificate:%s
does not exist.
FTP port has been
changed to port %s.
FTP port has been
changed to default
port.
SNMP port has been
changed to port %s.
SNMP port has been
changed to default
port.
Console baud has been
changed to %s.
Console baud has been
reset to %d.
DHCP Server on
Interface %s will not
work due to Device HA
status is Stand-By
DHCP Server on
Interface %s will be
reapplied due to
Device HA status is
Active
Appendix A Log Descriptions
DESCRIPTION
An administrator changed the port number for HTTP back to the default (80).
An administrator changed the port number for SSH.
%s is port number assigned by user
An administrator changed the port number for SSH back to the default (22).
An administrator assigned a nonexistent certificate to SSH.
%s is certificate name assigned by user
After an administrator assigns a certificate for SSH, the device needs to
convert it to a key used for SSH.
%s is certificate name assigned by user
An administrator changed the port number for TELNET.
%s is port number assigned by user
An administrator changed the port number for TELNET back to the default
(23).
An administrator assigned a nonexistent certificate to FTP.
%s is certificate name assigned by user
An administrator changed the port number for FTP.
%s is port number assigned by user
An administrator changed the port number for FTP back to the default (21).
An administrator changed the port number for SNMP.
%s is port number assigned by user
An administrator changed the port number for SNMP back to the default (161).
An administrator changed the console port baud rate.
%s is baud rate assigned by user
An administrator changed the console port baud rate back to the default
(115200).
%d is default baud rate
If interface is stand-by mode for device HA, DHCP server can't be run.
Otherwise it has conflict with the interface in master mode.
%s is interface name
When an interface has become the HA master, the DHCP server needs to start
operating.
%s is interface name
NXC Series User's Guide
394