ZyXEL Communications NXC2500 User Manual page 410

Table 213 CAPWAP Client Logs
LOG MESSAGE
AP Receiving Complete ZySH
Configuration from WLAN
Controller.
AP Receiving Updating ZySH
Configuration from WLAN
Controller.
STA List Full. STA List of AP [%s]
is Full
DNS Query result is NULL.
Table 214 AP Load Balancing Logs
LOG MESSAGE
kick station
%02x:%02x:%02x:%02x:%0
2x:%02x
Table 215 Rogue AP Logs
LOG MESSAGE
rogue ap detection is
enabled.
Table 216 Wireless Frame Capture Logs
LOG MESSAGE
Capture done!
check_size:%d,
max_file_size:%d\n
Can not initial
monitor mode signal
handler.\n
Table 217 DCS Logs
LOG MESSAGE
dcs init failed!\n
init zylog fail\n
Appendix A Log Descriptions
DESCRIPTION
WTP receiving total configuration from WLAN Controller during
CAPWAP protocol handshaking. (Configuration Change State)
WTP receiving total configuration from WLAN Controller When
AC changed configuration. (RUN State)
Number of stations connecting to the specified AP has reached
its upper limit.
1st %s: WTP's description.
A DNS query failed.
DESCRIPTION
Indicates that the specified station was removed from an AP's wireless
network because the AP became overloaded.
DESCRIPTION
Indicates that rogue AP detection is enabled.
DESCRIPTION
This message displays check_size %d and max_file_size %d when the wireless
frame capture has been completed.
1st %d: total files size of directory.
2nd %d: max files size.
While an AP is in Monitor mode, the handler functions as a daemon; if it fails to
initialize the handler, then this message is returned.
DESCRIPTION
Indicates that the NXC failed to initialize the dcs daemon.
Indicates that the NXC failed to initialize zylog.
NXC Series User's Guide
410