Traffic Statistics - ZyXEL Communications NXC2500 User Manual

Table 26 Monitor > System Status > Interface Status (continued)
LABEL
Status
TxPkts
RxPkts
Tx B/s
Rx B/s

5.5 Traffic Statistics

Click Monitor > System Status > Traffic Statistics to display this screen. This screen provides
basic information about the different kinds of data traffic moving through the NXC. For example:
• Most-visited Web sites and the number of times each one was visited. This count may not be
accurate in some cases because the NXC counts HTTP GET packets.
• Most-used protocols or service ports and the amount of traffic on each one.
• LAN IP with heaviest traffic and how much traffic has been sent to and from each one.
You use the Traffic Statistics screen to tell the NXC when to start and when to stop collecting
information for these reports. You cannot schedule data collection; you have to start and stop it
manually in the Traffic Statistics screen.
Chapter 5 Monitor
DESCRIPTION
This field displays the current status of each interface. The possible values depend on what
type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected. This field displays the
port speed and duplex setting (Full or Half).
For VLAN interfaces:
Up - The VLAN interface is enabled and one of its member Ethernet interfaces is
connected.
Down - The VLAN interface is enabled but none of its member Ethernet interfaces is
connected.
Inactive - The VLAN interface is disabled.
This field displays the number of packets transmitted from the NXC on the interface since it
was last connected.
This field displays the number of packets received by the NXC on the interface since it was
last connected.
This field displays the transmission speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
This field displays the reception speed, in bytes per second, on the interface in the one-
second interval before the screen updated.
NXC Series User's Guide
62