ZyXEL Communications NXC2500 User Manual page 128

Figure 68 Configuration > Network > Interface > VLAN
Each field is explained in the following table.
Table 63 Configuration > Network > Interface > VLAN
LABEL DESCRIPTION
Configuration / Use the Configuration section for IPv4 network settings. Use the IPv6 Configuration
IPv6 section for IPv6 network settings if you connect your NXC to an IPv6 network. Both sections
Configuration have similar fields as described below.
Add Click this to create a new VLAN.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
Remove To remove an entry, select it and click Remove. The NXC confirms you want to remove it
before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Object Select an entry and click Object Reference to open a screen that shows which settings use
Reference the entry.
# This field is a sequential value, and it is not associated with any interface.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Name This field displays the name of the interface.
IP Address This field displays the current IP address of the interface. If the IP address is 0.0.0.0 (in the
IPv4 network) or :: (in the IPv6 network), the interface does not have an IP address yet.
In the IPv4 network, this screen also shows whether the IP address is a static IP address
(STATIC) or dynamically assigned (DHCP).
In the IPv6 network, this screen also shows whether the IP address is a static IP address
(STATIC), link-local IP address (LINK LOCAL), dynamically assigned (DHCP), or an IPv6
StateLess Address AutoConfiguration IP address (SLAAC). See
more information about IPv6.
VID This field displays the VLAN ID number.
Member This field displays the Ethernet interface(s) that is a member of this VLAN.
Apply Click Apply to save your changes back to the NXC.
Reset Click Reset to return the screen to its last-saved settings.
Chapter 8 Interfaces
NXC Series User's Guide
128
Appendix E on page 440 for